Pulling Power
Wayne Scraba breaks down the best method and tools to install or remove a harmonic damper.
Articles by Wayne Scraba
Digging Into The Internal Engine Void: Handheld Vacuum Gauges
A time tested means to determine the internal condition of an engine is by way of a good old fashioned vacuum gauge.
Working With Flat Tappets Part 2
Part 2 of Wayne Scraba’s series on Flat Tappets continues to provide instruction on getting the most out of this type of camshaft.
Working with Flat Tappets Part 1
Wayne Scraba’s newest series leads readers through the mysteries of flat tappets.
Front End Shortcuts Part 2
Wayne Scraba brings us 12 more short cuts for front end work.
Front End Shortcuts Part 1
Wayne Scraba brings us a dozen tips for more easily fixing your front end in this first of a two part series.
MR. Clean: Prepping An Engine Block For Assembly
Although it is possible to build an engine almost anywhere, a clean environment is a must.
Setting Up Shop Part 2
In our last issue, we took a look at some of the procedures along with the tools you’ll most likely need to gather before embarking […]
Setting Up Shop Part 1
Wayne Scraba kicks off a new series about organizing your shop for a big build.
More Torque: Bolt Stretch and Torque Angle
Using a stretch gauge to increase the accuracy of your torque and torque measurement with this follow up article on torque.