Ford Provides Details on Three Safety Recalls for North American Models

Ford has released an update on three safety recalls for their vehicles. If you have a Ford F-350, Ford Explorer, or Lincoln Aviator please read over these recalls.

Safety recall for certain 2020-2021 Ford F-350 Super Duty vehicles with 6.7-liter engine and single rear wheel axle for a rear axle housing spring seat interface weld issue
Ford is issuing a safety recall for approximately 34,939 Ford F-350 Super Duty vehicles with 6.7-liter engine and single rear wheel axle for a rear axle housing spring seat interface weld issue.

Affected vehicles may experience rear driveline disconnection. Customers may experience vibration and/or shaking while driving at highway speeds, and/or shuddering upon acceleration. In the event of a disconnected driveshaft, customers may experience loss of motive power while driving or loss of transmission park function if the parking brake is not applied, increasing the risk of a crash.

This action affects 34,855 vehicles in North America, with the remaining balance in Ford’s International Markets Group. Vehicles were built at Kentucky Truck Plant between Aug. 6, 2020 and May 15, 2021.

Ford is not aware of any accidents or injuries related to this condition.

Owner notifications will begin the week of Aug. 16. Dealers will inspect rear axle to determine if deformation is present. If the axle is deformed, the axle housing will be replaced. If axle is not deformed, the dealer will perform a weld repair on the spring seats. The Ford reference number for this recall is 21S31.

 

Safety recall for select 2013-2017 Ford Explorer vehicles that may experience a seized cross-axis ball joint
Ford is issuing a safety recall for approximately 774,696 2013-2017 Ford Explorer vehicles that may experience a seized cross-axis ball joint that may cause a fractured rear suspension toe link. Affected vehicles may experience a clunk noise, unusual handling, or a misaligned rear wheel. Fracture of a rear toe link significantly diminishes steering control, increasing the risk of a crash.

This action affects approximately 676,152 vehicles in North America, 59,935 in China, 25,257 in Ford’s International Markets Group, 13,162 in Europe and 190 in South America. In the U.S., the affected vehicles are located in high-corrosion states as defined by the National Highway Traffic Safety Administration or in regions with a combination of cold winter weather with relative high humidity and substantial road salt use.

Vehicles were built at Chicago Assembly Plant between Sept. 4, 2012 and Sept. 30, 2017, and Elabuga Assembly Plant in Russia between Jan. 28, 2013 and July 28, 2017.

Ford is aware of six allegations of injury related to this condition in North America.

Owner notifications will begin the week of Aug. 23. Dealers will inspect the cross-axis ball joint, replace the cross-axis ball joint/knuckle as necessary, and replace the toe links with a revised design part. The Ford reference number for this recall is 21S32.

Ford is providing a customer satisfaction program for vehicles not sold or registered in corrosion states.

 

Safety recall for select 2020-2021 Lincoln Aviator vehicles equipped with 3.0-liter gas engines for improperly secured battery cable wire harnesses
Ford is issuing a safety recall for approximately 40,995 2020-2021 Lincoln Aviator vehicles equipped with 3.0-liter gas engines because the battery cable wire harness may not be properly secured, allowing contact with the A/C compressor pulley. Over time, the A/C pulley may rub through the wire harness insulation and contact the unfused battery positive (B+) circuit, resulting in a short circuit and potential fire.

This action affects approximately 36,258 vehicles in North America, 2,601 in Ford’s International Markets Group, and 2,136 in China.

Vehicles were built at Chicago Assembly Plant between June 19, 2019 and Jan. 5, 2021.

Ford is not aware of any accidents, injuries or fires related to this concern.

Owner notifications will begin the week of July 30. Dealers will inspect the vehicle, and:

  • If there is no evidence that the battery cable has contacted the A/C compressor pulley, they will add a tie strap near the frame rail between the battery cable harness and the engine compartment harness.
  • If any of the small gauge circuits are damaged, dealers will add a tie strap near the frame rail between battery cable and engine compartment harnesses and replace the A/C compressor belt.
  • If any of the four large gauge circuits are damaged, dealers will inspect the wire harness and replace the battery cable harness and will also add a tie strap near frame rail between battery cable harness and engine compartment harnesses and replace the A/C compressor belt.

The Ford reference number for this recall is 21S34.

Be the first to comment

Leave a Reply

Your email address will not be published.


*


I agree to receive emails from RacingJunk.com. I understand that I can unsubscribe at any time. Privacy Policy