When left you in the last article in the series, we showed how Van Steel (website: www.vansteel.com) stripped the C3 Corvette rear end center section, in preparation for blueprinting along with the install of 30-spline stub axles (Chevy calls them “Side Gear Yokes”).
![[Video] Project Chevelle: 9-Inch Rearend Install](https://www.racingjunk.com/news/wp-content/uploads/2018/10/vvwvwevwev-376x206.png)
The Project Chevelle boys are ready to get launching after they’ve installed their new 9-inch out back.
It’s not rocket science. Sure, setting up ring and pinion gears can seem challenging, but it really is simple enough that anyone can do it—If they’re willing to pay attention to proper procedures.
Like I mentioned in the article about lowering front ends, getting your car low to the ground allows you to go faster and enhances control. Also […]
