Powerglide governor support

Old 12-02-2012, 06:55 PM
  #1  
travis91
Junior Member
APPRENTICE
Thread Starter
 
Join Date: Jul 2007
Location: Gainesville, FL
Posts: 19
Default Powerglide governor support

I am rebuilding my powerglide and need some help. I took it apart a few months ago and mixed the governor support up with others on my bench. I am using a manual GM VB w/a full tree brake. I have 3 governor supports and am not sure which one was on this case with this valve body. Two of the supports are the early version with one having the priming valve still and wear plate with gasket and the other one has no priming valve and a blockoff plate and then I have one later version support with no plate that would only use a gasket. I am guessing this is basic knowledge for a tranny guy but I am at a loss. Thanks in advance for any help.
travis91 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service