Holley 4150 HP idle air bleed change refresher course.

Old 09-28-2011, 06:41 PM
  #1  
markdunlap
Senior Member
DYNO OPERATOR
Thread Starter
 
Join Date: Jan 2004
Location: central Illinois
Posts: 459
Default Holley 4150 HP idle air bleed change refresher course.

OK, need a refresher.

If I have throttle blades set with approx. .040" idle slot showing below blades, and my 4 corner idle screws give best idle at only 1/4 turn from full in, am I lean or rich?

Will changing the air idle jet sizes allow adjustment to 1 1/2 turns out on screws and will this be any better idle quality than the 1/4 turm out?

Bigger idle air jet will lean fuel/air mixture?

What else is there to getting better idle quality?

377 SBC with .520 hydraulic roller cam, 750 HP carb, 21 degrees initial and 38 degrees total timing, 7-8" vacuum at idle, 1000 RPM idle in neutral, 800 RPM in gear, 3500 RPM converter.
markdunlap is offline  
Old 09-29-2011, 09:06 AM
  #2  
jmarksdragster
Senior Member
RACING JUNKIE
 
jmarksdragster's Avatar
 
Join Date: Jul 2007
Location: Florida
Posts: 635
Default

Rich, go the next drill size larger on the idle air bleeds.
jmarksdragster is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service