Found very low voltage on my Trans Brake Switch up

Old 09-25-2011, 03:00 PM
  #1  
Pdmracing
Member
CRAFTSMAN
Thread Starter
 
Join Date: Oct 2007
Posts: 53
Default Found very low voltage on my Trans Brake Switch up

I was wiring up my practice tree to my Biondo TB switch & it wouldnt work on the tree, but on any other switch I tested it worked.
I then took a voltage meter when it was hot normal 12 volts when open it was reading between .09 & .06 volts

I disconected the msd 2 step to see if any difference & still showed the same small voltage.
is this switch bad?
Pdmracing is offline  
Old 09-26-2011, 06:56 PM
  #2  
Pdmracing
Member
CRAFTSMAN
Thread Starter
 
Join Date: Oct 2007
Posts: 53
Default

biondo says its ok, you must disconect any box/transbrake to use the tree any voltage from the tree will try to power stuff.
Dont use your tree with 12 pover applied to switch!
Pdmracing is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service