SBC 350 distributor sits at angle w/single plane manifold

Old 06-15-2010, 06:01 PM
Junior Member
Thread Starter
Join Date: Nov 2007
Posts: 4
Default SBC 350 distributor sits at angle w/single plane manifold

Hi all, I recently purchased a `72 350 060 over sbc with a hurricane type single plane intake on it. Had no disributor in it when I bought it and has never been fired.(total rebuild) I finally got a distributor for it and dropped it in and the distributor sits at an angle?? The seat on the intake is flat(horizontal). Is this a special intake, maybe for a later model sbc? or is this the way distributor is suppose to sit in the motor.....I`m baffled?? Seems to me that the distributor hole is not in line with the hole in the block I`ve seen manifolds that actually have an angled seat for the distributor. Is this what I need?? Any help would be greatly appreciated.
r66novaL79 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -