head gasket

Old 04-18-2010, 05:39 AM
  #1  
clwarters
Junior Member
SHOW GUEST
Thread Starter
 
Join Date: Oct 2009
Location: greenville nc
Posts: 9
Default head gasket

i am installing a set of Pro Comp PC5213 CHEVY SBC 400 ULTRA HIGH PERFORMANCE STAINLESS MULTI-LAYER HEAD GASKETS Three layers of pure 304 stainless steel
Outer layers embossed and coated on both sides with Viton a state of the art flourelastomer rubber based material
but not shure what side should face up ,raised or concaved , i put raised up but had to knotch for oil stick always installed raised side up but hope this was rite and will work they were knotched for oil stick flipped this side down STEEL gaskets raised side up i alway thought
clwarters is offline  
Old 04-24-2010, 07:40 AM
  #2  
ccperf721p
Senior Member
SENIOR BUILDER
 
Join Date: Nov 2008
Location: Phoenix AZ
Posts: 116
Default

I haven't seen the pro comp gaskets, but I would assume they are similar to the FelPro and Cometics. With Cometic and FelPro there is no specific orientation. Either side can go up.
ccperf721p is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service