dominator

Old 04-05-2010, 04:36 PM
  #1  
rich970
Junior Member
APPRENTICE
Thread Starter
 
Join Date: Aug 2005
Posts: 16
Default dominator

I have a question is there a feeler gauge setting for the dominator throtle plates as a starting point ? i thought i read it somewhere . Thanks
rich970 is offline  
Old 04-08-2010, 03:07 PM
  #2  
jmarksdragster
Senior Member
RACING JUNKIE
 
jmarksdragster's Avatar
 
Join Date: Jul 2007
Location: Florida
Posts: 635
Default

Not a feeler gauge, but you should have around .020 exposed on primary and secondary. They will look like little squares. If you have to raise the idle speed a little, work the secondary first. If you have to go to much because of a large cam/low idle vacuum AND the making sure the timing is optimized, you will need to drill small holes in the throttle blades to add idle air without excessively uncovering the t-slots. Start with a 3/32 hole in the primaries, add secondaries if needed. Best position is directly below the idle discharge port as shown below. "X" marks the spot.



jmarksdragster is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service