need help ???

Old 07-21-2009, 03:50 PM
  #1  
gpracer
Junior Member
JOURNEYMAN
Thread Starter
 
Join Date: Aug 2005
Posts: 29
Default need help ???

i have a chevy big block and cannot get my valves to stop making noise and motor to run right if i set them at 1/4 turn runs great but at 1/2 a turn runs like crap it is a hydraulic cam all i know is it is a rv cam i have tried setting them diffrent ways from what i have read online and none of them work what am i doing wrong the motor ran fine b4 i broke a pushrod and lifter so i changed oput them for new ones and now got this problem any help ty?????
gpracer is offline  
Old 07-21-2009, 04:21 PM
  #2  
ejm
Senior Member
SENIOR BUILDER
 
Join Date: Nov 2007
Location: indiana
Posts: 123
Default

is it while driving its making noise? if so i'd check timing? jmo
ejm is offline  
Old 07-21-2009, 10:32 PM
  #3  
gpracer
Junior Member
JOURNEYMAN
Thread Starter
 
Join Date: Aug 2005
Posts: 29
Default

not while driving timing is at 36 degrees i have had no problems setting lifters on other motors b4 just no matter what i do i have rocker arm noise i am thinking mabe valve springs weak ??? thanks for any suggestions anybody has
gpracer is offline  
Old 07-22-2009, 04:33 AM
  #4  
CamBirdRacing
Senior Member
DYNO OPERATOR
 
Join Date: Feb 2009
Posts: 510
Default

Built a 468 for my buddies 68 Camaro. When we took the dual plane of and put a single plane on it, you could hear the lifter noise thru the bottom of the intake since there was only a thin piece of aluminum covering the lifter galley. I would go 1.4 turn.

How do you adjust them? With it running or off? I always do my hydralics with it running.
CamBirdRacing is offline  
Old 07-30-2009, 06:42 AM
  #5  
mopar1962
Member
JUNIOR BUILDER
 
Join Date: Nov 2008
Posts: 87
Default

Maybe you have a collapsed lifter...
mopar1962 is offline  
Old 07-30-2009, 04:45 PM
  #6  
hotrodharley
Senior Member
EXPERT BUILDER
 
Join Date: Dec 2002
Location: spring creek nv.
Posts: 328
Default

just stabing at this but what about cam lobe flatten on the lobe you lost the lifter and pushrod on?adjust them all again and run car then go back and check and see if the lifter that you replaced is loose again.maybe the cam lobe is flatten on you.something to look at.
hotrodharley is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service