nos fogger problems

Old 05-05-2008, 06:40 AM
  #1  
michael1
Senior Member
MASTER BUILDER
Thread Starter
 
Join Date: Jan 2006
Posts: 237
Default nos fogger problems

I have a tunnel ram that someone drilled for a nos fogger system but they had every hole stripped out. Is there any way to fix this without welding the holes up and starting over? I know BG makes a npt reducer bushing, has anyone had this problem, if so how did you fix it? The holes are 1/8 inch so I can go bigger. Thanks for any help you give.
michael1 is offline  
Old 05-05-2008, 07:21 AM
  #2  
v8Fiero
Senior Member
MASTER BUILDER
 
Join Date: Nov 2007
Location: Wisconsin cheesehead!!
Posts: 213
Default

that sucks, you can either get new thread inserts or use an adapter like they give you with universal shift knobs. both work the same basic way and shouldnt disrupt flow much more then before. be sure to seal them up tight with thread sealent glue.
v8Fiero is offline  
Old 05-12-2008, 09:39 AM
  #3  
racecrafter
Junior Member
JOURNEYMAN
 
Join Date: Feb 2008
Posts: 29
Default

If you can find heli-coil inserts in the proper thread they should work as long as the holes havent been made too large. once again use sealer....no teflon tape!!!
racecrafter is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service