SCE ICS TITAN HEAD GASKETS

Old 02-07-2008, 06:42 PM
  #1  
lanham
Senior Member
MASTER BUILDER
Thread Starter
 
Join Date: Dec 2005
Location: berea,ky
Posts: 184
Default SCE ICS TITAN HEAD GASKETS

Has anybody used these gaskets for BBC.These are the copper gaskets with the built in o-ring and the silicone beads on the water and oil passages.Just wandering if these work or not and if they require a slick finish on the block and heads like the MLS gaskets require.Thanks
lanham is offline  
Old 02-07-2008, 07:43 PM
  #2  
knova70
Senior Member
SENIOR BUILDER
 
Join Date: Feb 2005
Posts: 121
Default

I used them on a SBC,I had no luck with them tried 2 sets and had to send them back to sce,and then I just oringed my block and used the standard copper head gasket and now I have no problems at all, If I were you and didn't want to o-ring your block use cometic head gaskets and they require a smooth head and block surface.
knova70 is offline  
Old 02-10-2008, 06:22 AM
  #3  
thetanman101
Member
JUNIOR BUILDER
 
Join Date: Sep 2005
Location: East Texas
Posts: 86
Default

I've got them on my 496. Fresh motor, so can't give much info yet. My last set of MLS's burned through between cyl. 4 & 6, cutting a gouge half as thick as my little finger into my iron heads. Have since upped the compression, so I wanted more protection for my new high dollar aluminum heads. I really like their design.

-Tanner

P.S. I believe Ken is using them also, so you might PM him about them. You will have to retorque these gaskets after first couple of heat cycles. Mine didn't back off, but others have had water leaks if they didn't retorque, as advised by the company.
thetanman101 is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service