S-10 SBC

Old 10-04-2007, 03:47 PM
  #1  
gullion454
Member
MASTER JOURNEYMAN
Thread Starter
 
Join Date: May 2003
Posts: 35
Default S-10 SBC

I am installing a sbc in a 95 S-10 with front and mid plates, and I was wondering if the engine needs to sit level front to back? I have it level side to side but am have trouble with the front to rear. I think it is about a 1/4 of a inch off (the front is higher). Any help would be great. Thanks
-aaron-
gullion454 is offline  
Old 10-04-2007, 06:40 PM
  #2  
jbsjunk
Senior Member
EXPERT BUILDER
 
Join Date: Apr 2004
Posts: 279
Default

Usually putting a level on the carb pad on the intake will find that you are pretty close to level where it sits. If it's not, adjust accordingly. Most intakes are cast with some angle built in them. If you can't get it close, Moroso makes carb wedge plates.
jbsjunk is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service