Burst panel
06-27-2007, 12:26 PM
#1
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Apr 2006
Location: Ms.
Posts: 191
Burst panel
Has any of you guys ever used the Wilson Manifolds burst panel carb spacer plates, I just ordered one should save some butterflys in the event of hitting the rev limiter.
06-27-2007, 10:05 PM
#3
Senior Member
DYNO OPERATOR
Join Date: Feb 2006
Location: VA Hospital, Dallas, Tx (214 302 1924) cell-972-464-7400
Posts: 540
If you are talking about the spring-loaded panels;
IT looks like a good piece. Speed Tech Panels are the ones I use. This was their idea and Wilson must have thought it was a good one. Now Wilson offers the same idea but is using 4 bolts instead of two.
If you are talking about the Wilson Burst panels or burst Windows or Burst Plugs that are replaceable like replacing freeze plugs, that idea was ok till something better showed up.
About hitting the rev-limiter. Oop's not a good idea when spraying nitrous.
Ed
IT looks like a good piece. Speed Tech Panels are the ones I use. This was their idea and Wilson must have thought it was a good one. Now Wilson offers the same idea but is using 4 bolts instead of two.
If you are talking about the Wilson Burst panels or burst Windows or Burst Plugs that are replaceable like replacing freeze plugs, that idea was ok till something better showed up.
About hitting the rev-limiter. Oop's not a good idea when spraying nitrous.
Ed
