Deadenbear case

Old 05-23-2007, 09:53 PM
  #1  
novassx
Junior Member
APPRENTICE
Thread Starter
 
Join Date: Aug 2004
Location: Vancouver Island B.C.
Posts: 11
Default Deadenbear case

When I bought my car it was a roller, It came with a drive shaft with a Mark Williams yoke. The trans I purchased has a Deadenbear case and tail shaft housing with roller bearing. The yoke is incorrect for the tail shaft, I know it is for stock type glide with bushing. Can I cut it down to fit the roller bearing. They give the correct measurements at the Mark Williams site. If I cut it down to fit, Does it have a harden surface? Don't really want to purchase a new yoke. This one is like new!
This the 1 I have: (Manufactured from high strength Heat treated 4340 steel forgings. 100% machining creates a perfect balanced part.)
Thank Gerald
novassx is offline  
Old 06-21-2007, 11:18 AM
  #2  
CHEETAHRON
Junior Member
SHOW GUEST
 
Join Date: Jan 2007
Posts: 8
Default

call mark williams, if it is thru hardened you can turn it down. if it was nitraded( hardened on the outside) it probly wont work, at the least you would have to get it re- hardened. 8)
CHEETAHRON is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service