Push rod length

Old 05-29-2017, 09:11 AM
  #1  
hotrodharley
Senior Member
EXPERT BUILDER
Thread Starter
 
Join Date: Dec 2002
Location: spring creek nv.
Posts: 328
Default Push rod length

Building a 496 bbc;deck has only been cleaned and flaten out;;head gasket is .080[needed to drop comp due to decide to street use eng and wanted to be able to use pump gas]have afr oval v2 alum heads;;comp hyd roller cam xm284hr-12[547 lift]howaeds hyd roller lifters #91161;;;and comp cams #1620-16 roller rockers;;;put stock push rod in and checked patteren on valve stem and riding on edge of valve stem[toward outside of head]put my adjustable push rod in and rechecked;;same location;;no matter how short or long i make the adjustable push rod i still showing rocker roller setting on edge of valve steam;;;what am i missing or doing wrong;;first time checking push rod lengths;[i'm using marker on stem so can see line where rocker is riding and rotating eng where valve opens and closes at least 2 times];since heads says will need .200 to .250 longer push rod i figure i should check it;;;lot of money in eng and don,t want to destroy it by having wrong push rods;;
hotrodharley is offline  
Old 05-29-2017, 04:53 PM
  #2  
curtisreed
Senior Member
RACING JUNKIE
 
curtisreed's Avatar
 
Join Date: Feb 2004
Location: KIEFER, OK.
Posts: 1,311
Default

If you can't get it to move no matter where you put the length of the pushrod checker, I would look toward the rocker having the wrong pivot to roller tip length.

You might watch this video about checking midlift geometry.

https://www.youtube.com/watch?v=o5is9BsH5OU
curtisreed is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service