Trans. case broke...
#1
Member
JOURNEYMAN
Thread Starter
Join Date: Jan 2008
Location: Newcomerstown, OH
Posts: 33
Trans. case broke...
I have a 72 chevelle back halved ladder bar setup, 6 point cage. I was running all solid motor and trans mount. My trans case broke towards the back right by the round thing that a bench mount transmission stand screws into on the left side up ove the top and then back to where the vaccum modulater mounts.
it is just a mild 350sbc, TH350 with shift kit, 5.14 gear footbrake car. Runs low 8.2s in the 1/8 and ran 7.72 on 100hp shot of nitrous
I now know that I shouldn't run all 3 solid mounts, I have installed a poly mount now. Just curious what else would have caused this and what else should I check to hopefully not happen again?
I hope to be getting a 10 point cage here soon, maybe even a 12 point.
Any help is greatly appreciated.
Thanks,
Travis
it is just a mild 350sbc, TH350 with shift kit, 5.14 gear footbrake car. Runs low 8.2s in the 1/8 and ran 7.72 on 100hp shot of nitrous
I now know that I shouldn't run all 3 solid mounts, I have installed a poly mount now. Just curious what else would have caused this and what else should I check to hopefully not happen again?
I hope to be getting a 10 point cage here soon, maybe even a 12 point.
Any help is greatly appreciated.
Thanks,
Travis
#3
NEVER, EVER run a solid trans mount. Chassis flex will break the trans. Just because a Chevelle is a full frame car does NOT mean it doesn't flex. The 71 Chevelle I used to have was inconsistent until I welded a roll bar to the frame. BIG DIFFERENCE. That gave me a clue as to how much it was flexing. Put at least a bar in the car, cage is better. ASAP. But still no solid trans mount.