4 link question

Old 06-23-2017, 01:01 PM
Junior Member
Thread Starter
Join Date: Jan 2004
Location: mogadore,ohio
Posts: 18
Default 4 link question

I want to lower my top bars 1 hole. Problem is there isn't any holes left. My bottom bars are level.what would happen if i raised the bottom bar up 1 hole? In essence, would that have the same result as moving the top bars down? I can weld new tabs on to make the top bar lower 1 hole but was wondering if raising the bottom would do the same thing. Thanks
mikeshemi is offline  
Old 06-28-2017, 06:03 AM
Senior Member
curtisreed's Avatar
Join Date: Feb 2004
Location: KIEFER, OK.
Posts: 1,312

No, raising the bottom won't do the same thing. It will move your intersect point back and up.

Moving the front of the top bar down moves your intersect point back and down. Check out the video below.


curtisreed is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -