not sure what to do
 

ok I was freshening up my 468 from a car i just bought you know rings and bearings so i thought i would throw in a new set of scat I beam rods when balancing everything we find that all my pistons are junk and my block is junk because the bores are not square with the crank anyways heres what i have now got a fresh block a set of srp 13:1 pistons and this set of scat I beam rods dart pro 1 320cc heads and a .714 lift roller cam do yall think these rods will survive in this engine I was going to send the rods back and exchange them for H beam but the shop had started balancing the rods so im kinda stuck with them any thoughts would be helpfull.

What was the part number on your Scat rods ?

2-ICR6135 (Rated to 700 horsepower)
2-ICR6135-7/16 (Rated to 800 horsepower)

the number i have is sca-26135 with 7/16 cap screws