Rewiring race car
 

Looks like I am going to have to rewire my race car,what's your opinion Painless or K&R. Which one is easier since I am not that great with wiring!Any help would be appreciated. Thanks Mike :?:

We had used painless on the first 3 or 4 dragsters. The last one we decided to go K&R. After using the K&R set up, I will not go back to painless. The instructions are easy to follow, nice chart for those the like to see the layout versus having to read the instructions and great customer service if you need to call.

them two names shouldnt be in the same sentence anymore lol

k&r is sweet !!

K&R for sure!!

I have the Biondo Mega Dial Panel with the dial board all built in. It was real easy to install and has been flawless. I dont have any experience with the K&R but it looks very similar. Here is a link to both.

http://www.biondoracing.com/MegaPanel.shtml

http://www.krperformance.com/wiringkits.cfm

I have used a couple of Painless set ups. But from what I've seen of the K & R harnesses, I think I'm going with K & R next time.

TS1955

Thanks for your opinions. I see a lot of dragsters using K&R, I run a door car is it the same set up? I looked on there site and there is a panel box for the roll bar also they say the kit comes with a new solenoid, why is that? Thanks again. Mike

comes with a ford solenoid so you only have to run the main wire to the starter.