CURRIE REAR END
 

CURRIE REAR END WITH THE ALUMINUM CENTER HOUSING???[NOT THE PUMPKIN]--GOOD / BAD / OR THE UGLY?---MOSTLY STREET USE AND SOME 1/8 MILE--WHAT DO YOU THINK FOR MY RANCHERO GASSER?-LIVELY

Are you asking if its a good housing or are you selling it? :?:

looking at one and wondering about the strength and limits of it 8) 8) LIVELY

I think it would be fine for street use, but would stay away for race purposes.

I have been running Currie stuff for years with no problems... 9" N section, 4.88 pro gear and 35 spline spool and there race axles NO PROBLEMS HERE WITH 1.000 HP 866 Tq Eng in a 3150LBS CAR

Unless I misunderstood the question, sounds like he's talking about aluminum center with steel axle tubes? I don't think that's what your running? :?:

Oh my mistake

Look this guy up and have his rear end guy help you out.
http://rides.webshots.com/video/3026...01149359WVpyxw

HE IS LUCKY HE DIDN'T LOSE IT ON THE PASS BEFORE!!!!---THAT IS ON THE PREVIOUS VIDEO 8) 8) 8) ----THE CURRIE REAR I LOOKED AT HAD THE ALUMINUM CENTER PIECE[WAS VERY NICE LOOKING BUT I WAS NOT SURE OF THE STRENGTH]---THANKS FOR THE INFO===LIVELY

Hello Lively,Just thought with your inquiry about the rear axle housing I have a 9" on the classified side if interested,Thanks Dragman28. :)

The WOW factor for those rear ends is awesome Yes It will hold up to your application AND THEN SOME
Here is the link to them really pretty cheap for what ya get & add $75.00 more bucks & have them polish it COOL 8)

http://www.currieenterprises.com/ces...E.aspx?id=1567