Rupert Lean out valve

[dynaguy03]

I see many people have this "dial" like lean out valve made by Rupert using vacume.
Where can i get one? Looks like Rupert doesnt have a website.

Thanks
Keith

[hammertime]

I see many people have this "dial" like lean out valve made by Rupert using vacume.
Where can i get one? Looks like Rupert doesnt have a website.

Thanks
Keith

Not sure what the dial one is, but before he used to just send a normal lean out valve you could get from mcmaster carr

[dynaguy03]

Thanks David... do you know what they might call such a thing in this massive McMaster -Carr catalog "Abyss"..lol

[curtisreed]

Keith,

Go to this page

http://www.mcmaster.com/#catalog/115/455/=1mnr5p

Easy slide sleeve valve about half way down the page. 4622k55 is one if the link doesn't work.

Curtis

[hammertime]

Keith,

Go to this page

http://www.mcmaster.com/#catalog/115/455/=1mnr5p

Easy slide sleeve valve about half way down the page. 4622k55 is one if the link doesn't work.

Curtis


Thats it, I used it when I ran rupert stuff.

[dynaguy03]

Curtis /David

Thanks for your help .. i have a Mc Master Carr close .. so i went and picked up the valve.. its exactly like the ones i see on everyones car.. was pretty cheap too!!
Off i go with the gas to Alky conversion.. i hope this goes smooth.. just waiting on my APD 950

THANKS AGAIN
Keith

[curtisreed]

Keith,
Which part number did you get exactly? The one I ordered was black, most that I have seen were red. Just wondering. Thanks.

Curtis

[hammertime]

Curtis /David

Thanks for your help .. i have a Mc Master Carr close .. so i went and picked up the valve.. its exactly like the ones i see on everyones car.. was pretty cheap too!!
Off i go with the gas to Alky conversion.. i hope this goes smooth.. just waiting on my APD 950

THANKS AGAIN
Keith

they are much cheaper then the carb places sell them for :D