U-weld it sheet metal intake kits

[racecrafter]

Looking to replace the two dominator sheet metal intake that was stolen from my shop.....saw on racing junk the company selling kits that can be welded by the buyer. has anyone run one of this company's intakes either in a pre-welded version or purchased a weld it your self version and completed it?
It is going to be used on a 632 nitrous motor .....big chief heads...the usual junk.....

[Racefab57]

Who has the kit your interested in???? David.

[racecrafter]

the company/web site is Weinlemotorsports.com.....they have an add in the drag race engine parts classified section of this (RacingJunk)site

[gimmemud]

Here is one ready to go almost as cheap as the u weld kit

http://www.racingjunk.com/post/1140430/CFE-BIG-CHIEF-18-SHEET-METAL-INTAKE.html

This is not my ad, just something I found

[racecrafter]

thanks, I am keeping that add in mind but I would have to make spacers and would rather not if i dont have to.....but again thank you.

[gimmemud]

Keep in mind if you do the uweld kit, there is some serious porting that will have to be done also. I considered that route, but instead went with Beck Mechanical in Houston Tx. for a new one.

His website is WWW.Beckmechanical.com