Autofab Race Cars Mustang Bolt-on Battery Cut off switch kit

E1020

This kit is designed to fit into the holes for the passenger side tail light. As you can see from the pictures there will be minimum work involved in this kit. We designed this to be closest to the right rear tire as possible without needing much modifications because the battery when moved is usually put over the passenger side tire to help with traction. The only modification would be to drill a small hole in the sheet metal in between the license plate and tail light. This kit is a one of a kind to try and make your Mustang look as streetable as possible so that you can keep your "Sleeper" look. Why give more hints that you have a bad a$$ car if you dont have to. This kit is very easy to install and we guarantee you will be happy with our product. We also offer battery cable kits and custom battery trays to complete the relocation of your battery to the rear of your car.

Installation instructions for master cut off switch

1.) Start by removing (right hand passenger side) rear interior trim panel; taillight panel.

2.) Remove right side taillight.

3.) Attached template provided in kit to outer taillight panel above to outer taillight panel above rear bumper using masking tape.

4.) Align holes on right side template to left holes on taillight.

5.) Using a 15/32 drill bit to drill hole as shown in template.

6.) You may want to touch up paint around new hole to prevent rust (Any color can be used because grommet will cover it).

7.) Install grommet (push from outside in).

8.) Reinstall taillight. Attached aluminum bracket to left side of right taillight, sandwiching the bracket between the taillight and the original nuts.

9.) Install master cut off switch with lever pointing to the upper left.

10.) Install rod through grommet.

11.) Install nylock on threaded end off rod (just till nylock bites).

12.) Rotate master cut off switch until punch pull rod has smooth action.

13.) Reinstall taillight panel (taillight panel with have to be notched).



THANK YOU FOR USING OUR KITS



This kit includes the following:

1) Master Cutoff switch

2) Mounting Bracket

3) Push/Pull Rod

4) "T" Handle

5) Rubber Grommet

6) All Hardware Needed to Install



(You will need to supply the 15/32" drill bit and the required wrenches to install the kit.)

Phone - 410 796 8777
Fax - 410 796 2006

Seller Phone Number: 410-796-8777

This item is NEW

Trades NOT ACCEPTED

Payment options:

Item Location: ELKRIDGE, MD Get Directions

This ad expires in 1 day.