www.RaceDaySafety.com
770-505-0193
___________________________________
New design features for improved comfort and performance, same protection that only a HANS Device can provide. The HANS Sport II is quickly becoming the preferred head and neck restraint for racers. The rounded collar reduces the weight of the Sport II and it allows easier entry/exit of the race car if still attached to the helmet.
• SFI 38.1 and FIA 8858 certified
• Sliding tethers come standard, for increased side to side vision capability.
• Injection molded – lighter than Sport I, slightly heavier than the Pro Series (approx. 3/4 lb.).
• Smaller collar constructed from a new DuPont polymer reduces weight.
• Includeds all hardware, full instructions, plus a helmet anchor wrench.
• Available in the Post Anchor System or the Quick Click Anchor System. Both systems enable the driver to easily attach and detach the HANS Device while still in the race car.
The Post Anchor is the most common system. The HANS is attached to the helmet by aligning the tether hardware to the helmet hardware, pushing in and sliding the tether rearward. To release, realign slots on tether hardware to flats on helmet hardware and slide forward.
The Quick Click is the anchor system which allows the driver to quickly detach the HANS by pulling on the orange tethers. To attach the HANS to the helmet anchors, open anchor by pulling orange release strap, slide tether loop over hasp and close.
Above Added: Mon June 10, 2013, 6:53 pm EST
NecksGen now offers 3 sizes, a Large unit which fits most adults, typically a driver over 5'6" and over 100 lbs. Their Medium is for drivers 5' to 5'6" and over 100 lbs. Compared to the large unit, the medium is 1" narrower in center. NecksGen also offers a Youth unit, which fits small torso drivers, typically youth drivers between 7 and 16 years old who are under 5' and 100 lbs. Compared to the large unit, the youth unit is 1" narrower at the neck and 1" narrower at each shoulder platform where the seat belt goes (to accommodate only a 2" seat belt).
Above Added: Sat December 29, 2012, 10:04 am EST
The NecksGen is the next generation of Head and Neck Restraints. Made in the USA and fabricated from DuPont carbon fiber composite material. Not only are these materials lightweight, but they are extremely strong. The NecksGen has passed all SFI testing and is currently SFI 38.1 Certified and tagged.
Accepts 2” or 3” seat belts. The side wings keep the shoulder harness belts in place under impact or loose belt conditions. The guides on the upper chest area keep the unit centered on the driver at all times, not allowing the unit to slip from under the belts.
The unit is adjustable to fit most seat angles from 10°-40°. This also allows the driver to adjust the back of the unit for comfort as well as interference with the helmet or seat.
The low profile design allows easy access from confined areas with no interferance on roll bars.
The body forming Kevlar pads fit under the seat belt, therefore taking any pressure off the collar bone and making the unit very comfortable.
Offers a full range of head motion while still providing side and angular impact protection.
Included with the NecksGen: Quick-Release & Hard Mount Helmet Hardware, Flex-Fit Cap, Decal Kit, Patch & Carrying Bag (does not include helmet)
Business Information
