Up for sale is a complete CS-4 lenco, big shaft bruno, bellhousing and converter.
# Big shaft Bruno, non-lock up, with extra drum and band.
# CS-4 three speed Lenco with 160 first gear and 118 second gear. Was completely redone by Lenco in 2020 and has less than 20 runs since. Repair/rework alone cost, $5500 receipt attached in photos.
#Big block Chevy bellhousing, non-lock up, by Trick Titanium 6 -5/16 can. Has the Hass, Bickel, chassis mounts. I have the original factory box.
Is out of Cert., would need to be sent in if you need current certification. I could even send it out for you but at your cost.
#100 % machined billet bolt together torque converter by Bradco. 10-3/4 bolt circle with 6 mounting pads, uses 1/2 inch attaching bolts. Specialty converter spec. for 800 plus inch nitrous motor. Can also provide you with a Meziere 168 tooth billet flex plate. Showing some wear but very useable.
This combination was last run behind an 800-inch nitrous motor @ 2500 lbs. Ran multiple mid 3.90's @ 186 MPH. with .960- 60' at Milan Dragway quick 8 in October 2021 for the win.
Motivated seller but will not give it away, possible trades considered on race car stuff only.
All associated shipping or transport cost is the responsibility of buyer. May be able to deliver to a PDRA event.