1.76 Standard set in POWERGLIDE
#1
Senior Member
SENIOR BUILDER
Thread Starter
Join Date: Oct 2005
Location: Wellington , New Zealand
Posts: 122
1.76 Standard set in POWERGLIDE
I have just bulit a Powerglide.It has a Standard 1.76 gear set. Hughes transbrake valvebody.TCI steel Hub , Kevlar band and alto red race frictions.It has a duel servo piston and standard reconed pump and a JW ultra Glide.My question is How much horsepower will this handle?
#2
Senior Member
RACING JUNKIE
Join Date: May 2006
Posts: 2,044
I'd say in the neighbor hood of 750 hp. You didn't mentioned what input shaft your running though? You'll definetly need to upgrade to a hardened turbo spline input shaft if your considering throwing any kind of real power to it if you havent already. JMO
Charles
Charles
#5
I have seen 1,000 hp run on these 1.76 set ups with no immediate problems in a 2600/2700 lb car...
Not saying i endorse this or not......my tranny guy says 800hp no problems with a 3,000 lb ball park range..
i now run 180 straight cuts but have a spare 1.76 in the shop..
i agree with the input shaft statement..spend $300 and get you one of those trans specialties ringless HI-FLOW input shaft..the one rated up to 1500 hp..
if ya want to stick with a hardened stock type turbo shaft...give me a pm i have one of those to...notice its in extra parts box...
Brian
Not saying i endorse this or not......my tranny guy says 800hp no problems with a 3,000 lb ball park range..
i now run 180 straight cuts but have a spare 1.76 in the shop..
i agree with the input shaft statement..spend $300 and get you one of those trans specialties ringless HI-FLOW input shaft..the one rated up to 1500 hp..
if ya want to stick with a hardened stock type turbo shaft...give me a pm i have one of those to...notice its in extra parts box...
Brian
__________________
Bjuice..
"I'M YOUR HUCKLEBERRY ! "
Bjuice..
"I'M YOUR HUCKLEBERRY ! "
#6
Senior Member
SENIOR BUILDER
Thread Starter
Join Date: Oct 2005
Location: Wellington , New Zealand
Posts: 122
The input shaft is a hughes 4340 hardened type with powerglide spline.The car is a 1250kg backhalved 9 inch 4.11 ratio.Ive heard alot of differant horswpower and weight combos but i just want to get a final figure on it.
#7
Senior Member
RACING JUNKIE
Join Date: Sep 2007
Posts: 4,137
I have factory 1.76 planets in mine with a COAN input shaft, brake and servo .I have it in a 3050 lb car with a 540 bbc. Don't know the HP it makes but it runs low 6's in the eighth (hopefully will bust the 5's this year with new heads and camshaft.) Works ok so far.
#9
Originally Posted by jrthone
The input shaft is a hughes 4340 hardened type with powerglide spline.The car is a 1250kg backhalved 9 inch 4.11 ratio.Ive heard alot of differant horswpower and weight combos but i just want to get a final figure on it.
but by all means run it..if it breaks then you know what to do..
good luck Mate...
Hey you live anywhere close to the "Worlds Fastest Indian" Guy, Burt Munro ?
__________________
Bjuice..
"I'M YOUR HUCKLEBERRY ! "
Bjuice..
"I'M YOUR HUCKLEBERRY ! "