algin honing mains
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Sep 2008
Posts: 9
algin honing mains
i'm building a 406 for the 1/8 mile only. i am using main studs is it absolutely neccessary to algin hone the mains? or will it create problems if i don't. any advice would be great! my budget is getting thin just don't now if this has to be done
#2
Junior Member
APPRENTICE
Join Date: Nov 2007
Posts: 17
I think I can answer that from a engine builder stand point.
Irregardless of whether you use studs or not it likely needs this operation anyway.
It's too your benefit. Old blocks move around and take a set, not always in the right place either. Now that it's stable doing the main bores will make it a better than new block and will stay that way.
Dave Koehler
http://www.koehlerinjection.com
Irregardless of whether you use studs or not it likely needs this operation anyway.
It's too your benefit. Old blocks move around and take a set, not always in the right place either. Now that it's stable doing the main bores will make it a better than new block and will stay that way.
Dave Koehler
http://www.koehlerinjection.com