How do you mesure base circle?
#12
Originally Posted by zipper06
Originally Posted by doorracer
Originally Posted by zipper06
Doesn't make sence too me why you guys are making this so hard :shock: If the cam is installed, all you have to do is set up a 2" travel indicator (you do need to know the exact cam lift) pickup the lowest point on the cam. Then rotate the engine to the highest lift C/L. Then subtract the lowest point form the highest point, then subtract the total cam lift, you then have the base circle dia.If you don't have a 2" travel indicator use a 1" and set a 1/2" spacer under the indicator at the lowest point. If the cam is not installed, you can generally mike/measure across the C/L of the cam, since most cams donot start the lift before the halfway point on the cam (this won't be exact but will get you close enough to tell if you have a small BC cam or not) I too am a machinest for over 50yrs. and have a surface plate in my home shop and micrometers 0 to 12", plus a 1/2 doz. indicators, dial bores,Height gage, etc.
Just my 2 cents
Zip.
Just my 2 cents
Zip.
Curtis
Zip.
PS Curtis, CNC programming and operating CNC equipment is also what i do for a living when i work, at a plastics injection mold building com.
#14
Junior Member
JOURNEYMAN
Join Date: May 2003
Posts: 25
The closest way to check it with dial calipers is....
Measure a cam journal and divide by two to find the centerline.
Then measure down from the cam journal to the base circle of the lobe.
Subtract this measurement from 1/2 the jounal diameter. This gives you the base circle radius.
Multiple that by 2 to get the base circle diameter.
Again, this is only acurate for +/- .002" or so.
Works well on a surface plate with V blocks and a digital indicator that reads in tenths (.0001)
Measure a cam journal and divide by two to find the centerline.
Then measure down from the cam journal to the base circle of the lobe.
Subtract this measurement from 1/2 the jounal diameter. This gives you the base circle radius.
Multiple that by 2 to get the base circle diameter.
Again, this is only acurate for +/- .002" or so.
Works well on a surface plate with V blocks and a digital indicator that reads in tenths (.0001)
#15
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
If you're on a surface plate with v-blocks, just mic. the bearing journal, divide by 2,= C/L keep that number. Put your drop indicator on top of the cam bearing journal, set (0) then drop down the the heel of the cam. take that number from the kept number and multiply the what's left by 2 and you have the base circle.
Zip.
Zip.