cam break in
#1
Senior Member
EXPERT BUILDER
Thread Starter
Join Date: Jul 2009
Location: nekoosa wisconsin
Posts: 308
cam break in
when doing my cam break in i know i need about 2000 rpms at about 20 min
can i just set the idle high and let it run or do i have to manualy do it with my foot
thanks logan
can i just set the idle high and let it run or do i have to manualy do it with my foot
thanks logan
#2
Senior Member
MASTER BUILDER
Join Date: Nov 2005
Location: Mobile,Al.
Posts: 127
cam
If it's a flat tappet cam,I like to vary the rpm's and not let it stay in the same rpm range for a long period of time 1800 to 2500 or so.I if it's a solid roller,5 minutes bring up to temp,shut it down and check fluid levels,look for leaks and reset lash and timing.then straight to the race track.!!!!LOL
#4
Re: cam
Originally Posted by contagious
If it's a flat tappet cam,I like to vary the rpm's and not let it stay in the same rpm range for a long period of time 1800 to 2500 or so.I if it's a solid roller,5 minutes bring up to temp,shut it down and check fluid levels,look for leaks and reset lash and timing.then straight to the race track.!!!!LOL
#5
Member
CRAFTSMAN
Join Date: Dec 2010
Location: anchorage alaska
Posts: 56
Dont forget to take the long bolt that holds the fuel pump rod in place and install the short bolt as a plug to prevent oil from spraying out the front of the block. learned that one the sucky way.