I dont have a th 400 or thats what I would put in it . I have a fresh 350 just sittin around, I think I might throw it in this week. Is there someone who makes pre bent trans lines?? I hate buyin a strait set and bending them myself, they end up lookin horrible :lol:
I have two fittings that go in the trans that go to a #6 line and then to a trany cooler. If you allready have a trany cooler that has screw in adapters I can hook you up with fittings for it(let me know if the inlet is 1/8th,1/4,or 3/8 npt) fittings for the trany, and two #6 lines(let me know if you need straight to straight or straight to 45 or 90 etc). It is used stuff but nothing wrong with it. I'll take $25 and that includes shipping.
I pulled the side cover off the muncie it all looked fine, so I unbolted the bearing cover on the input shaft and found the big nut that keeps the bearing tight on the input shaft was loose. I checked the trans over pretty good and think that was my problem. I'm gonna stick it back in this week.
If you have any more troubles, theres a friend of mine in SE Indiana thats great with those trans. has the trick parts and reasonable. We're both members of a stick league UMTR.