Small block Mopar thrust bearing problem
#1
Junior Member
APPRENTICE
Thread Starter
Join Date: Sep 2021
Posts: 13
Small block Mopar thrust bearing problem
I haven’t ever seen this before, but the crank looks to be pushed forward from the torque converter and is wearing down the thrust bearing. This is a cast crank 340; there is about a 1/8 to 3/16 gap unbolted between flex plate and converter. Spins freely, and moves back and forth easily. The forged crank 340 has no problem with same Trans and converter. Any ideas?? Thanks
Last edited by Harbone; 11-26-2021 at 03:00 AM.