ZEX Perimter Plate system
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Aug 2007
Posts: 9
ZEX Perimter Plate system
I like the idea and design of this nitrous plate system. Does anyone have any experience with these or know of someone that does?
http://www.zex.com/Pages/82/Carb-Perimeter%20Plate.aspx
Thanks
http://www.zex.com/Pages/82/Carb-Perimeter%20Plate.aspx
Thanks
#5
Senior Member
RACING JUNKIE
Join Date: May 2006
Posts: 2,044
Originally Posted by coloradoracerguy
Not to hijack this thread, but does anybody know how it would work with a cloverleaf style intake, 4500 flange?
Thanks
Thanks
I suppose it would not work as them plates are pretty square, maybe on top of a open spacer?
Dam it Jim, back to the drawing board...
Cp
#6
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
We put a XEX on the 468" 3700lb Biscyne with a 2" spacer. At first we had it installed on top of the spacer and it performed like crap. We were then told to install it below the spacer, the car picked up 3 tenths, i think it might be the same with a cloverleaf manifold, but i'm only guessing. Now this car weighs 3700 lbs plus without driver and it runs 6.20's in the 1/8 mi. Don't know what it will run in the qtr. since the change but it ran 10.31 before the change.
Zip.
Zip.