Will this work?
#1
Senior Member
DYNO OPERATOR
Thread Starter
Join Date: Jan 2003
Location: Douglasville Ga
Posts: 474
Will this work?
Hey guys,
My work has some 12AWG electrical wire that is rated for 600 volts. It is the stranded kind. Only thing I can tell that is different is the insulation on it. I am going to be wiring up my new car here in the next couple of weeks and wanted to make sure this wire would work. Its insulation reads gas and oil resitant so I figured it would be a little better. Thanks in advance for any input adn or suggestions.
Chris
My work has some 12AWG electrical wire that is rated for 600 volts. It is the stranded kind. Only thing I can tell that is different is the insulation on it. I am going to be wiring up my new car here in the next couple of weeks and wanted to make sure this wire would work. Its insulation reads gas and oil resitant so I figured it would be a little better. Thanks in advance for any input adn or suggestions.
Chris
#3
Senior Member
DYNO OPERATOR
Thread Starter
Join Date: Jan 2003
Location: Douglasville Ga
Posts: 474
Originally Posted by dak697
Chris look on the wire...it will be stamped or will have printed on it what type of wire it is. Send me an PM on what is on the wire and I can tell you if it is a good choice....Dean