Stroking BBC
#2
Senior Member
MASTER BUILDER
Join Date: Dec 2004
Location: out of my mind in Kalamazoo, MI
Posts: 179
Re: Stroking BBC
Originally Posted by jreiley
How big can a bbc be stroked before the block has to be machined. The block is stock gm. Thanks.
I saw this out there and I tought I would try to answer this....the short deck or tall deck depends on the crank and rods you are going to use usually if going to a 4.125 throw crank you will need to clearance the rods on the oil pan rail...now I'm not sure about the tall deck but be aware that at some point you will need to clearance the crank and rod throws depending on how big you are going....I think the new casting for the big inch crate motors that GM is offering already has those considerations in mind hence the big cubic inch numbers...maybe somebody else has an idea
#3
Senior Member
RACING JUNKIE
Join Date: May 2006
Posts: 2,044
I used a stock 454 block and put 4.25 eagle rotating assembly in and everything cleared, even a stock oil pan without notched rails cleared.
Maybe I got lucky who knows but I do know the later 454 blocks i've seen do have a little relief cast into the pan rails which looks like it was meant to accomodate a longer stroke. JMO> Cp
Maybe I got lucky who knows but I do know the later 454 blocks i've seen do have a little relief cast into the pan rails which looks like it was meant to accomodate a longer stroke. JMO> Cp
#5
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Aug 2007
Location: Iowa - USA
Posts: 218
Re: Stroking BBC
Originally Posted by radicalz
Originally Posted by jreiley
How big can a bbc be stroked before the block has to be machined. The block is stock gm. Thanks.
I saw this out there and I tought I would try to answer this....the short deck or tall deck depends on the crank and rods you are going to use usually if going to a 4.125 throw crank you will need to clearance the rods on the oil pan rail...now I'm not sure about the tall deck but be aware that at some point you will need to clearance the crank and rod throws depending on how big you are going....I think the new casting for the big inch crate motors that GM is offering already has those considerations in mind hence the big cubic inch numbers...maybe somebody else has an idea