First runs with new car!
#22
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Sep 2008
Location: Red Deer, AB Canada
Posts: 213
Originally Posted by hammertime
I'd bet its shifting correct just not reading correct in the mega 450 box.
I'll bet you end up atleast at 2.00 seconds also at shift time
I'll bet you end up atleast at 2.00 seconds also at shift time
#23
Senior Member
RACING JUNKIE
Join Date: May 2003
Location: Coldwater, MI
Posts: 2,998
Originally Posted by kod99
Originally Posted by hammertime
I'd bet its shifting correct just not reading correct in the mega 450 box.
I'll bet you end up atleast at 2.00 seconds also at shift time
I'll bet you end up atleast at 2.00 seconds also at shift time
hit setup untill you get to a screen with juse a tach and a 00.00 on it for digits below the tach, there will be nothing on the bottom of this screen and will look empty compared to other screens. Push the up arrow, watch it untill you see what rpm it shifted at @ 1.75 seconds I'll bet 6600ish
#25
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Sep 2008
Location: Red Deer, AB Canada
Posts: 213
Originally Posted by hammertime
Originally Posted by kod99
Originally Posted by hammertime
I'd bet its shifting correct just not reading correct in the mega 450 box.
I'll bet you end up atleast at 2.00 seconds also at shift time
I'll bet you end up atleast at 2.00 seconds also at shift time
hit setup untill you get to a screen with juse a tach and a 00.00 on it for digits below the tach, there will be nothing on the bottom of this screen and will look empty compared to other screens. Push the up arrow, watch it untill you see what rpm it shifted at @ 1.75 seconds I'll bet 6600ish
#26
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Sep 2008
Location: Red Deer, AB Canada
Posts: 213
Just wanted to thank you all for your help. I set the box to bracket mode this weekend and have so far figured out the delay (most of my lights were 0.0?? and even had a 0.003) and shift point portion. I'm taking baby steps and will post here for more help as I get into the finer points of the Mega 450. Thanks again!
#27
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Sep 2008
Location: Red Deer, AB Canada
Posts: 213
I think I made another error with the delay box last weekend. I turned off the SLE function. I wasn't launching as hard as I thought I should and was wondering why. Was I not getting up on the two step without the SLE turned on? When I was on the trans brake the car would only rev to about 2300 RPM and never seemed to come up to 6800 RPM before launch. Any input would be appreciated.