nitrous jet sizing
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Jan 2008
Posts: 3
nitrous jet sizing
when chosing jet sizes for nitrous systems, should you go by the plate manufacturer or the solenoid manufacturer?
I have NX solenoids and an edlebrock plate, should I use the edelbrock jet map chart?
I have NX solenoids and an edlebrock plate, should I use the edelbrock jet map chart?
#3
Senior Member
SENIOR BUILDER
Join Date: Feb 2005
Location: LAWTON MI
Posts: 113
Go by the plate the jets go in the plate and the plate does the mixing
Unless your solenoids are too small they will out flow the plate
Solenoid = on/off
jet = restriction/calibration
plate= mixing/distribution of fuel
Unless your solenoids are too small they will out flow the plate
Solenoid = on/off
jet = restriction/calibration
plate= mixing/distribution of fuel
#5
Senior Member
SENIOR BUILDER
Join Date: Nov 2008
Location: Phoenix AZ
Posts: 116
Normally I would say go with the plate, but Edelbrock's jet map is on the rich side by quite a bit. But there are other factors to consider as well.
Which NX nitrous side solenoid do you have? The 15100 is a small orifice solenoid which will make a difference in N2O jet sizing.
Which NX nitrous side solenoid do you have? The 15100 is a small orifice solenoid which will make a difference in N2O jet sizing.