YSI Mustang Cog Set Up
06-10-2010, 12:23 AM
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Nov 2009
Posts: 1
YSI Mustang Cog Set Up
I have a 1993 Mustang Coupe with a 306 Boss Block, Brodix Heads, 700 lift cam, Scat Internals, YSI Blower. This engine revs to around 7500 RPM. The Blower came with a 28 tooth 30mm blower pulley.
I have now gone though a belt each time I have stepped on it. It does not have a twin plate bracket.
I talked to a very well known shop and they said that a 30mm belt will not stand up to the rpm (7500). Vortech seems to think it is the lack of a twin plate bracket.
I now have no idea how to fix this without majors mods (convert to drivers side and a 50mm belt which is very expensive).
DOES ANYONE HAVE ANY IDEAS??!??!??!?!?
I have now gone though a belt each time I have stepped on it. It does not have a twin plate bracket.
I talked to a very well known shop and they said that a 30mm belt will not stand up to the rpm (7500). Vortech seems to think it is the lack of a twin plate bracket.
I now have no idea how to fix this without majors mods (convert to drivers side and a 50mm belt which is very expensive).
DOES ANYONE HAVE ANY IDEAS??!??!??!?!?
