Throttle body size
#1
Junior Member
SHOW GUEST
Thread Starter
Join Date: Jun 2003
Posts: 1
Throttle body size
I'm looking at putting a P1SC kit on my '98 Ram V10 (8.0L). I'm just going with the 8psi kit to help with towing. Exhaust is a no-brainer but on the intake side it turns out the V10 uses the same TB as a 5.2.
What confuses me is the TBs are flowed using vaccuum, not boost. If the procharger puts out 1200 cfm max, which of these TB's would you guys suggest? A little smaller to retain velocity or bigger to allow max air through there? These are my options:
980cfm
1050cfm
1100cfm
I've never messed with forced induction before, so your help is appreciated. Thanks!
What confuses me is the TBs are flowed using vaccuum, not boost. If the procharger puts out 1200 cfm max, which of these TB's would you guys suggest? A little smaller to retain velocity or bigger to allow max air through there? These are my options:
980cfm
1050cfm
1100cfm
I've never messed with forced induction before, so your help is appreciated. Thanks!