(very) small block Chevy

Old 09-11-2009, 12:11 AM
  #1  
ElCamino66
Junior Member
SHOW GUEST
Thread Starter
 
Join Date: May 2008
Posts: 1
Default (very) small block Chevy

I have an old 283 engine that I've been storing because it's the correct replacement for the one in '66 ELCamino, but I'm thinking about building it now as a 301 like we did way back in the dayto power a light weight little chopped and channelled Model T coupe that would be street legal but used more for drag racing. I'm thinking of running a glide with a 9" Ford and the weight should come in around 2200 pounds. I have a choice of a set of aluminum Chevrolet heads with 1.94 intakes or a set of cast iron Vortec heads also with 1.94s. I'm leaning towards the aluminum heads because I have a selection of intakes and carbs I could experiment with and they are all old style. I'd like to hear what you guys think about the head selection and also need some cam suggestions. I'd prefer to go with a hydraulic flat tappet 'cause basically I'm lazy but I'd consider a solid lifer or solid roller cam if that'll work. My intake choices are single palne, dual plane, old style dual quad single plane with 2 little 500 Holleys. I.m not looking to go lightning fast at this point but thought a hi wind'n tiny sbc would be a lot of fun in a light little coupe. How about compression ratio too? With it street driven occasionally I'd like to burn pump gas. Can I go a little higher on compression with the alloy heads?
ElCamino66 is offline  
Old 09-11-2009, 07:22 AM
  #2  
OneBadGMC
Senior Member
RACING JUNKIE
 
Join Date: Sep 2007
Location: Belleville, IL
Posts: 658
Default

What's the casting numbers on the heads?
OneBadGMC is offline  
Old 09-11-2009, 10:25 PM
  #3  
cepx111
Senior Member
RACING JUNKIE
 
Join Date: May 2006
Posts: 2,044
Default

"Can I go a little higher on compression with the alloy heads"

I've always heard that you could go a tad higher without detonation on aluminum heads cause they absorb the heat and get rid of it quicker, where as a iron head will retain the heat.

But still I wouldnt think it would be that much higher than a cast iron head though.

About 10.5 to 1 or 11-1 is as high as you want to go with pump gas, no matter what head your using.

Cp
cepx111 is offline  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service