Switching from Comp to Morel lifters
04-12-2009, 07:57 AM
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Dec 2005
Location: berea,ky
Posts: 184
Switching from Comp to Morel lifters
When switching from Comp Cams 819-16 standard height roller lifters to the Morel Ultra Pro .300 tall lifters part number from PBM RL982 will the pushrods be the same or will i need a different length pushrod? Thanks
04-12-2009, 12:47 PM
Senior Member
RACING JUNKIE
Join Date: Jan 2006
Location: La.
Posts: 2,890
Shorter pushrods required and if you're running shaft rocker setup, you really need to measure for the correct length, not saying it isn't a good idea to measure even with convention roller rockers.
JMO
Zip.
04-12-2009, 04:45 PM
Senior Member
RACING JUNKIE
Join Date: May 2003
Location: Coldwater, MI
Posts: 2,998
You may need new pushrods but should ALWAYS check to be sure
04-19-2009, 08:16 AM
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Dec 2005
Location: berea,ky
Posts: 184
I made the swap and the pushrods stayed the same.The pushrod seat location in the lifters measured the same between the two.
04-21-2009, 05:54 AM
Senior Member
RACING JUNKIE
Join Date: Dec 2008
Location: Sugar Hill, GA
Posts: 1,365
I know yours are .842, but what is the deal about the 1" dia units? They say the exhaust lifter has two sets of needle rollers. Is this a set inside a set? Dave
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off