Blower size and amount of boost.

Old 03-21-2009, 11:19 AM
  #11  
zipper06
Senior Member
RACING JUNKIE
 
Join Date: Jan 2006
Location: La.
Posts: 2,890
Default

I personally think the old hilborn 2 port injections would be plenty and would look better on your setup. If you watch ebay motors hilborn injections you'll see one turn up ocasionally and very reasonably, like $500.00/$600.00, i ran both the 2 port and 4 port, with small inch motors yrs. ago and the 2 port out performed the 4 port.

JMO

Zip.
zipper06 is offline  
Old 03-21-2009, 04:27 PM
  #12  
beuvbuilt
Junior Member
SHOW GUEST
Thread Starter
 
Join Date: Feb 2009
Posts: 6
Default

I think your right zip. I kinda had that in the back of my mind. its a little motor and the bug has 3 - 3" right? Ive been worried it might be a bit much. 2-3" might work better. I haven't talked to any injection guys yet about this set up. I've got a lot of work ahead. Hell, I still need to build a car to put it in.

Thanks all.
beuvbuilt is offline  
Old 03-29-2009, 06:42 AM
  #13  
ashbros
Senior Member
RACING JUNKIE
 
Join Date: Nov 2004
Location: St. Louis, Missouri
Posts: 661
Default

I have always had to block off one the the holes on a bug when using for similar set up. It is pretty simple to install a block off plate.

Either way a hilborn or enderly will give you a bad ass look sporting a blower.
ashbros is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -