I'm building a 632 bbc with two 1150's, I'm using a set of brodix big dukes (pb1802) and I need to know if this is to much carburetor for this combination. This is a pump gas drag car that weighs about 3400 lbs. Thanks
If you have them, try them. You may need to go up on jetting a little from factory sizes to make up for loss of booster signal at lower RPM's, smaller MAB's or both. If they are stock 3-circuit 1150's, you may run into the mainwells being restricted too much to get it rich enough at WOT. Spend the money for a dual O2 setup, it will help a bunch to set them up. Spend the time to make sure they open equally from closed to wide open.
the part # is 9377 it says they are used for a tunnel ram set up. I would really like to sell them and use 1050's. I think they would work perfect for all around use.