Hose Sleeves
08-11-2010, 03:49 PM
Senior Member
MASTER BUILDER
Thread Starter
Join Date: Aug 2007
Location: Iowa - USA
Posts: 218
Hose Sleeves
Is there a good way to cut these stainless hose sleeves to fit hoses I want tp cover? Hack Saw is not the best.
08-11-2010, 05:00 PM
Senior Member
RACING JUNKIE
Join Date: Aug 2007
Posts: 1,523
Wrap the point where you want to cut with vinyl tape and cut it with a dremel tool.
08-11-2010, 06:18 PM
Senior Member
RACING JUNKIE
Join Date: Mar 2008
Location: Emmett, Idaho
Posts: 7,334
I wrap mine with duct tape and cut with a cutoff saw. If you use a cutoff wheel on a die grinder or a cutoff saw, go SLOW so you don't catch the braid and unravel it all over. Just eeeeeease through it.
08-12-2010, 01:13 PM
Senior Member
RACING JUNKIE
Join Date: Mar 2006
Location: EUGENE,OR.
Posts: 3,391
Amen on both of those comments... make sure you wrap it tight.
08-12-2010, 06:34 PM
Senior Member
DYNO OPERATOR
Join Date: Jan 2003
Location: Douglasville Ga
Posts: 474
Same here, I just wrap the part I need to cut with tape and cut it with a cut off wheel.
Chris
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off