Acceptable offset between crank/trans input shaft
#1
Member
MASTER JOURNEYMAN
Thread Starter
Join Date: Oct 2008
Location: Desoto, MO
Posts: 37
Acceptable offset between crank/trans input shaft
With all of the adapter bellhousings and plates, it seems that the crank and input shaft on the trans may not be perfectly centered with each other. That being said, what is an acceptable amount of offset between the two? If it matters, this would apply to th350/400 trans.
#3
Member
MASTER JOURNEYMAN
Thread Starter
Join Date: Oct 2008
Location: Desoto, MO
Posts: 37
Originally Posted by zipper06
I don't know what the acceptable amount is but i can guarentee you if you have as much as .005 you will have a front seal leak very quickly after the trans is installed.
JMO
Zip.
JMO
Zip.