Results 1 to 5 of 5

Thread: Help on loading a low car on a open trailer

  1. #1
    Junior Member SHOW GUEST
    Join Date
    Apr 2003
    Posts
    5

    Help on loading a low car on a open trailer

    Have an open trailer and a low to ground clearance car, any suggestions or pictures on how to load without bottoming out. Have a tilt-a hitch receiver but that only gives a few inches to tilt back...

  2. #2
    Senior Member RACING JUNKIE TheYellaBrick's Avatar
    Join Date
    Mar 2008
    Location
    Emmett, Idaho
    Posts
    7,334
    Next would be using the trailer jack to raise up the front of the trailer and rear of your tow rig(leave hooked up). MAKE SURE you have the front tires of the tow rig are securely blocked. AND do NOT raise the tow rig so high you completely unload the rear suspension.
    After that a set of ramps to run the rear of your tow rig up onto. I've used both these methods numerous times over the years and still do when I haul my YELLA BRICK.
    Last edited by TheYellaBrick; 08-17-2014 at 09:48 PM.
    TRUTH is HATE
    to those who
    HATE TRUTH

    God Bless our folks in uniform
    "We the People, have your backs"
    http://www.racingjunk.com/profile/279898

  3. #3
    Senior Member RACING JUNKIE curtisreed's Avatar
    Join Date
    Feb 2004
    Location
    KIEFER, OK.
    Posts
    1,309
    I used to pull my roadster on an open trailer. I would have to put the back end of the trailer ramps on top of a set of the type of ramps that you use to work on your car. That let the car level out before the trans got to the end of the trailer. A friend of mine said it always looked like I was building a bridge when I loaded my car, but it got me to and from the track.

    Another option is to split tail the trailer. Does your trailer have a dovetail on it?

    Curtis

  4. #4
    Senior Member RACING JUNKIE
    Join Date
    Dec 2007
    Location
    ohio
    Posts
    810
    I had the same problem with my open trailer, i made longer ramps, and that took care of it.

  5. #5
    GO GET A SET OF 2x10s 10 ft long for ramps pin em on one end after loading slide under car strap down.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy