Results 1 to 1 of 1

Thread: Powerglide governor support

  1. #1
    Junior Member APPRENTICE
    Join Date
    Jul 2007
    Gainesville, FL

    Powerglide governor support

    I am rebuilding my powerglide and need some help. I took it apart a few months ago and mixed the governor support up with others on my bench. I am using a manual GM VB w/a full tree brake. I have 3 governor supports and am not sure which one was on this case with this valve body. Two of the supports are the early version with one having the priming valve still and wear plate with gasket and the other one has no priming valve and a blockoff plate and then I have one later version support with no plate that would only use a gasket. I am guessing this is basic knowledge for a tranny guy but I am at a loss. Thanks in advance for any help.

  2. Racing Junk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Copyright © 2005-2016 All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy