chassie dyno question

Old 05-31-2012, 01:52 PM
  #1  
dartsteve
Member
JOURNEYMAN
Thread Starter
 
Join Date: Dec 2008
Location: jacksonville florida
Posts: 34
Default chassie dyno question

So i took car to dyno to tune.
500ci and powerglide trans

First run i slowly brought up rpm to 1/2 throttle and let off, all was well made 505 hp
Second run adjusted main jet and throttle cable to get wot.
Put car in hi rev to 2500 and then stomped it. Got the shut down signal from dyno operator. Trans/converter not transfering power to wheels. Tried another run and same problem, any suggestions where to start, fluid clean and not hot. Trans and converter just freshened up at manufacter. They said auto trans and chassie not good together.
Thanks for any suggestions where to start
[/u]
dartsteve is offline  
Old 03-18-2014, 12:58 PM
  #2  
alexu
Junior Member
APPRENTICE
 
Join Date: Jun 2008
Location: rock hill sc, 29730
Posts: 15
Default

no reason to put car in reverse to stall a convertor it is going to slip till rpm is reached may need to have convertor checked because sometimes they need adjustment
alexu is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -