Results 1 to 2 of 2

Thread: chassie dyno question

  1. #1
    Member JOURNEYMAN
    Join Date
    Dec 2008
    Location
    jacksonville florida
    Posts
    34

    chassie dyno question

    So i took car to dyno to tune.
    500ci and powerglide trans

    First run i slowly brought up rpm to 1/2 throttle and let off, all was well made 505 hp
    Second run adjusted main jet and throttle cable to get wot.
    Put car in hi rev to 2500 and then stomped it. Got the shut down signal from dyno operator. Trans/converter not transfering power to wheels. Tried another run and same problem, any suggestions where to start, fluid clean and not hot. Trans and converter just freshened up at manufacter. They said auto trans and chassie not good together.
    Thanks for any suggestions where to start
    [/u]

  2. #2
    Junior Member APPRENTICE
    Join Date
    Jun 2008
    Location
    rock hill sc, 29730
    Posts
    15
    no reason to put car in reverse to stall a convertor it is going to slip till rpm is reached may need to have convertor checked because sometimes they need adjustment
    mccraw machine & performance parts
    170 davis street
    rock hill sc, 29730
    803-329-2343
    [email protected]


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy