Results 1 to 2 of 2

Thread: engine to trany spacer

  1. #1

    engine to trany spacer

    anyone know where to get a 5/8 inch spacer for chevy? what Im wanting to do is to run a 300mm 4l60e converter in a 700r4 ( md8 ) behind a ls engine. I have a trany ready with a long stator and the converter is hanging out to far. I have it spaced out using some 5/8 in. nuts and the pull up distance is perfect. my plan was to fab. a spacer from some 5/8 cold roll flat stoc. been looking around for a time saver , any ideas would be nice? thanks

  2. #2
    Senior Member SENIOR BUILDER
    Join Date
    May 2006
    Location
    Pikeville KY
    Posts
    109
    Hughes performance makes a 1" spacer for their new lock up pro mod power glide. It is made out of aluminum and they make it in house. I am sure they can cut you one that is 5/8 if you call them....
    OSCA PROSTREET CHAMPION 2006
    [email protected] 1.13 ALL AT 3200LBS

    2009 PRO STREET CHAMPION LONDON DRAGWAY 4.69 @153.00 3200LBS

    2011 LONDON DRAGWAY RECORD HOLDER IN PRO STREET 4.66 @153.00


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright © 2005-2016 RacingJunk.com All Rights Reserved.

Designated trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the RacingJunk.com
Terms of Use, Classifieds Disclaimer, Privacy Policy, and Cookie Policy